LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1350 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Range Selector Lever
    GM1970155Courtesy of GENERAL MOTORS CORP.
  1. Install the range selector lever (2).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the range selector lever nut (1).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    3. Fig 2: View Of Range Selector Lever Cable & Retainer
    GM1970184Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector lever cable (2) to the cable bracket.
  4. Install the range selector lever cable retainer (1).
  5. Connect the range selector lever cable (2) to the range select lever.
    6. Fig 3: View Of Range Selector Lever Cable Heat Shield
    GM1970183Courtesy of GENERAL MOTORS CORP.
  6. Install the range selector lever cable heat shield (2).
  7. Install the range selector lever cable heat shield bolts (1).

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals