Component Testing: TCCM
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Key OFF. Disconnect the X1 connector at the TCSCS.
- Using the L-BU probe J 35616-64B, connect a test light between the TCSCS harness as specified below for the LED being tested.
- Using the special function ability of the scan tool, command the affected LED ON and OFF. The test light should turn off and on as commanded.
- If the test light does not function as commanded replace the TCCM.
| Mode | 2 High | 4 High | 4 Low | N |
|---|---|---|---|---|
| Voltage - pin | 4 | 4 | 4 | 2 |
| Ground - pin | 7 | 9 | 10 | 3 |