Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Level Sensor

Courtesy of GENERAL MOTORS CORP.

Position the fuel level sensor over the slot in the reservoir and slide the sensor down into the slot.

Fig 2: Identifying Fuel Level Sensor Connectors & Clips

Courtesy of GENERAL MOTORS CORP.

Ensure that the fuel level sensor retainers (2) engage the module reservoir.
Install the fuel level sensor wiring pigtail under the module clip (1) behind the fuel pump wires.

Fig 3: Identifying Fuel Level Sensor Wiring Pigtail

Courtesy of GENERAL MOTORS CORP.

Connect the fuel level sensor wiring pigtail electrical connector (1) to the module cover.
Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement .