LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (1 Of 2)) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Small EVAP Rear Pipe Quick Connect Fittings
    GM1854510Courtesy of GENERAL MOTORS CORP.
  1. Position and connect the small EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    2. Fig 2: Locating Fuel Tank Clips
    GM1854508Courtesy of GENERAL MOTORS CORP.
  2. Position and connect the EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP rear pipe to the fuel tank clips (1 and 2).
    4. Fig 3: Locating Fuel Tank Clip
    GM1854507Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP canister purge pipe to the fuel tank clip (1).
  5. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals