LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (1 Of 2)) >> Repair Instructions >> Evaporative Emission Line Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible system contamination.
    Fig 1: View of EVAP Line & Canister Purge Solenoid
    GM1706143Courtesy of GENERAL MOTORS CORP.
  1. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the EVAP line quick connect fitting at the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP line quick connect fitting at the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals