LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (1 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CKP Sensor & Bolt
    GM1239292Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of Engine Wiring Harness Electrical Connector & Sleeve
    GM1964987Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  4. Position the engine wiring harness sleeve (2) over the CKP sensor electrical connection.
  5. Lower the vehicle.
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals