LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (1 Of 2)) >> Repair Instructions >> Barometric Pressure Sensor Replacement

Barometric Pressure Sensor Replacement

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Barometric Pressure Sensor, Retainer & Bolt
GM1999123Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
1 Bolt
CAUTION: Refer to Fastener Caution .

Tighten:  10 N.m (89 lb in)
2 Retainer
3 Barometric Pressure Sensor

Procedure

  1. Disconnect the BARO sensor harness connector.
  2. Remove the BARO sensor from the intake manifold.
scientia non olet · About LEMON Manuals