Removal Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the steering gear boot. Refer to Steering Gear Boot Replacement (HP2) or Steering Gear Boot Replacement (Without HP2) .
- Place a pipe wrench on the steering gear rack (1) next to the steering linkage inner tie rod housing (2).
- Place a wrench on the flats of the steering linkage inner tie rod housing (2).
- Rotate the steering linkage inner tie rod housing (2) counterclockwise, while holding the steering gear rack stationary, until the steering linkage inner tie rod separates from the steering gear rack (1).
NOTE:
After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.
CAUTION:
Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
CAUTION:
The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe wrench in any other location will cause damage to the steering gear.