LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Shaft/Cover Assembly, Bolts, Adjuster Nut & O-Ring (670 Gear)
    GM412387Courtesy of GENERAL MOTORS CORP.
  1. Install the new steering gear pitman shaft housing cover O-ring (4).
  2. Install the steering gear pitman shaft housing cover (3).
  3. Install the steering gear pitman shaft lash adjuster nut (2).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the steering gear pitman shaft housing cover bolts (1) and tighten to 62 N.m (46 lb ft).
    5. Fig 2: View Of Steering Gear Housing, Lock Washer & Nut
    GM740401Courtesy of GENERAL MOTORS CORP.
  5. Install the pitman arm washer (2).
  6. Install the pitman arm nut (3) and tighten to 250 N.m (184 lb ft).
  7. If necessary adjust the steering gear pitman shaft over-center preload. Refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle .
  8. Install the steering gear. Refer to Steering Gear Replacement (HP2) , Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (Hydraulic Rack and Pinion)  or Steering Gear Replacement (LMM) .
scientia non olet · About LEMON Manuals