LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assembly and Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (HP2) , Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (Hydraulic Rack and Pinion)  or Steering Gear Replacement (LMM) .
    2. Fig 1: View Of Cylinder Line Retaining Plate & Bolt
    GM1751420Courtesy of GENERAL MOTORS CORP.
    NOTE: Protect the steering gear boots from sharp tools and from the sharp edges of surrounding components.
  2. Remove the power steering gear inlet hose retaining plate bolt (1) and the power steering gear inlet hose retaining plate (2).
    3. Fig 2: Identifying Steering Gear Cylinder Pipe Seals, Pipes, Pipe Fittings & Steering Gear
    GM1989785Courtesy of GENERAL MOTORS CORP.
  3. Loosen both steering gear cylinder pipe fittings (3) on the steering gear (4).
  4. Remove both steering gear cylinder pipes (2) from the steering gear (4).
  5. Remove and discard the steering gear cylinder pipe seals (1) from the steering gear (4).
scientia non olet · About LEMON Manuals