Removal Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the drive belt. Refer to Drive Belt Replacement .
- Place a drain pan under the vehicle.
- Remove the bolts (1) from the rear of the pump.
- Remove the bolts from the front of the pump bracket.
- Disconnect the negative battery clip from the power steering pump front bracket.
- Remove the power steering return hoses (2, 4) from the power steering pump.
- Remove the power steering pump from the accessory mounting bracket to gain access to the power brake booster inlet pipe.
- Remove the power brake booster inlet pipe from the power steering pump.
- Remove the power steering pump from the vehicle.
- Remove the power steering pulley. Refer to Power Steering Pump Pulley Replacement (6.6L) or Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) .
- Remove the front bracket from the power steering pump.
- Remove the rear bracket from the power steering pump.
NOTE:
Note the location of the battery cables for reinstallation.