LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install all transferable parts as needed.
  2. Install the power steering pump assembly to the vehicle.
    3. Fig 1: Removing Power Steering Pump From The Vehicle (4.8L, 5.3L and 6.0L)
    GM346660Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Start all the bolts by hand before finalizing each torque.
  3. Install the power steering pump bracket bolt to the side of the engine.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  4. Install the power steering pump bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    5. Fig 2: View Of Power Steering Return Hoses, Clamps & Power Steering Pump
    GM898607Courtesy of GENERAL MOTORS CORP.
  5. Connect the power steering fluid cooler hose (4) and the power steering fluid cooler hose clamp (5) to the power steering pump assembly (1).
  6. If equipped with hydroboost, connect the power brake booster outlet hose (2) and the power brake booster outlet hose clamp (3) to the power steering pump assembly (1).
    7. Fig 3: View Of Power Steering Pressure Hose & Power Steering Pump
    GM898604Courtesy of GENERAL MOTORS CORP.
  7. Connect the power steering gear inlet hose (2) to the power steering pump assembly (1) from underneath the vehicle.

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  8. Clean any excess fluid power steering fluid from the vehicle and remove the drain pans.
  9. Connect the steering shaft coupling. Refer to Steering Shaft Coupling Replacement .
  10. Install the engine shield. Refer to Engine Shield Replacement .
  11. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (6.6L)  or Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) .
  12. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals