LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (6.6L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement .
    2. Fig 1: View Of Power Steering Pump Front Bracket & Bolts
    GM1891140Courtesy of GENERAL MOTORS CORP.
  2. Remove the power steering pump front bracket bolts (1, 2).
    3. Fig 2: View Of Power Steering Pump Rear Bracket & Bolts
    GM1891139Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering pump rear bracket bolts (1).
    4. Fig 3: View Of Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  4. Use the J 25034-C  to remove the power steering pump pulley. See Special Tools .
  5. Pull the power steering pump away from the accessory bracket to gain access to the pulley.
scientia non olet · About LEMON Manuals