Power Steering Gear Outlet Pipe/Hose Replacement (Gas Without Hydroboost)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Power Steering Gear Outlet Pipe/Hose & Components (Without Hydroboost)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the engine shield. Refer to Engine Shield Replacement .
1	Power Steering Gear Outlet Hose Clamp Procedure: Place drain pans under the vehicle as needed.
2	Power Steering Gear Inlet Hose Retaining Plate Bolt CAUTION: Refer to Fastener Caution . Tighten: 12 N.m (106 lb in)
3	Power Steering Gear Inlet Hose Retaining Plate
4	Power Steering Gear Outlet Hose CAUTION: Refer to Power Steering Hose Disconnected Caution . Procedure Disconnect the power steering gear outlet hose from the power steering fluid cooler. Pull the power steering gear outlet hose out of the steering gear. Keep all open connections in the power steering system clean and free of debris. Use the remover/installer J 44586 to replace the steering gear seals if necessary. See Special Tools . Fill and bleed the power steering system. Refer to Power Steering System Bleeding . Special Tools: J 44586 Power Steering Gear Oil Seal Remover/Installer. See Special Tools .