LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement (Gas With Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Gear Outlet Pipe/Hose & Components (With Hydroboost)
    GM1751501Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering gear outlet pipe (1) to the steering gear (2).
  2. Connect the power steering fluid cooler hose (3) and hose clamp to the steering gear (2).
  3. Clean any excess fluid from the vehicle and remove the drain pans.
  4. Fill and bleed the power steering system. Refer to Power Steering System Bleeding 

    .

scientia non olet · About LEMON Manuals