LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Gas With Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install drain pans under the vehicle as needed.
    2. Fig 1: View Of Power Brake Booster & Power Steering Gear Inlet Hose
    GM1861488Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Power Steering Hose Disconnected Caution .
    NOTE: Note the routing of the power steering gear inlet hose before removal. It MUST be routed correctly upon installation.
  2. Remove the power steering gear inlet hose (2) from the power brake booster (1).
  3. Remove the power steering gear inlet hose (2) from the power steering gear.
  4. Remove the power steering gear inlet hose (2) from the vehicle.
scientia non olet · About LEMON Manuals