Assembly Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and install the power steering fluid reservoir magnet (3).
- Install the power steering pump seals (1, 4, 5) to the power steering pump (2).
- Connect the power steering fluid reservoir (1) and the power steering pump (2).
- Install the power steering pump flow control valve spring (3) and the power steering pump flow control valve (2) to the power steering pump assembly (1).
- Install the power steering pump fitting seal (3) to the power steering pump assembly (1).
- Install the power steering pump fitting (4) to the power steering pump assembly (1).
Tighten: Tighten the fitting to 75 N.m (55 lb ft).
- Install the power steering fluid reservoir studs (2) to the power steering pump assembly (1).
Tighten: Tighten the studs to 58 N.m (44 lb ft).
- Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) , Power Steering Pump Replacement (6.6L) or Power Steering Pump Replacement (4.3L) .
CAUTION:
Refer to Fastener Caution
.
NOTE:
Start the power steering fluid reservoir studs and the power steering pump flow control valve fitting by hand before finalizing any torques.