LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield. Refer to Engine Shield Replacement .
  2. Place drain pans under the vehicle as needed.
  3. Remove as much power steering fluid from the power steering fluid reservoir as possible.
    4. Fig 1: View Of Power Brake Booster, Inlet Hose & Power Steering Pump
    GM650858Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Power Steering Hose Disconnected Caution .
  4. Disconnect the power brake booster inlet hose from the power steering pump (3).
  5. Disconnect the power brake booster inlet hose (1) from the power brake booster (2).
  6. Remove the power brake booster inlet hose (1) from the vehicle.
scientia non olet · About LEMON Manuals