Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Engine running, then center the steering wheel, observe the scan tool Steering Wheel Position parameter, the reading should be 0 +/- 10 degrees.
- If not within the specified range, perform the steering position torque sensor calibration, and verify DTC C0460 is not set as current.