LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Front Suspension System) >> Repair Instructions >> Upper Control Arm Replacement (2500, 3500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: View Of Upper Control Arm & Components
    GM793281Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the upper control arm bolts.

    Tighten:  Tighten the nuts to 190 N.m (140 lb ft).

  3. Connect the upper control arm to the steering knuckle.
  4. Install the new nut to the upper ball joint stud.

    Tighten:  Tighten the nut to 50 N.m (39 lb ft).

  5. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  6. Raise the vehicle and remove the support for the lower control arm.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals