Locking Differential Clutch Disc Assembly Assemble (10.5)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Locking Differential Clutch Disc Assembly (10.5 Inch Axle)

Courtesy of GENERAL MOTORS CORP.

Apply the proper axle lubricant to the surface of each disc. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Assemble the left side clutch disc assembly as follows:
1. Install the 1st non-carbon eared disc (2) to the side gear (1).
2. Install the 1st splined disc (3).
3. Install the 2nd non-carbon eared disc (4).
4. Install the 2nd splined disc (5).
5. Install the 3rd non-carbon eared disc (7).
6. Align the ears of all the clutch discs.
7. Install the guide clips (6) to the clutch discs (2-5, 7).
  Apply the proper chassis grease to the guide clips in order to hold the clips in place on the disc ears. Refer to Adhesives, Fluids, Lubricants, and Sealers .