Locking Differential Cam Unit Disassemble (11.5 Inch Axle)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Remove the retaining ring.

Fig 2: View Of Flange-End Side Cam Unit & Clutch Disc Assembly (11.5 Inch Axle)

Courtesy of GENERAL MOTORS CORP.

Disassemble the cam unit and clutch disc assembly as follows:
1. Remove the guide clips (6).
2. Remove the clutch discs and the splined discs (7-16).
3. Remove the wave washer (5).
4. Remove the fuse disc (4).
5. Remove the carbon eared disc (3).
6. Disassemble the cam plate (2) from the cam side gear (1).