Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Align the hub and the rotor.
- Install each of the new wheel studs into the hub and rotor assembly by performing the following:
- Install the stud.
- Install 4 washers to the stud.
- Install a lug nut to the stud with the flat side of the nut toward the washers.
- Tighten the lug nut to draw the stud into the hub and rotor assembly.
- Inspect the hub and rotor assembly to ensure the stud is seated completely.
- Remove the lug nut and the washers.
- Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
- With the engine OFF, gradually apply the brake pedal to 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 4-5 until a firm brake pedal is obtained. This will propely seat the brake caliper pistons and brake pads.
- Fill the master cylinder reservoir, if necessary. Refer to Master Cylinder Reservoir Filling (Non-Hybrid) or Master Cylinder Reservoir Filling (Two-mode Hybrid) .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- If the brake rotor was refinished or replaced, burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing .