LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1323 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2435 or B2440 >> Circuit/System Testing >> B2435 02 or B2435 05

B2435 02 or B2435 05

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2, X5 harness connectors at the MSM.
    2. IMPORTANT: When measuring the resistance, the resistance values are based on the seat being at room temperature of 20°C (68°F).
  2. Test for 850-300K ohms between the signal circuit terminal 4 X5 and the low reference circuit terminal 2 X2.
    • If greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits test normal, replace the seat back heater element/temperature sensor.
    • If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat back heater element/temperature sensor.
  3. Connect the X2, X5 harness connectors at the MSM.
  4. Disconnect the harness connector at the seat back heater element/temperature sensor.
  5. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal C and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the MSM.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the MSM.
  6. If all circuits test normal, replace the MSM.
scientia non olet · About LEMON Manuals