Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of BPMV Return Hose Quick Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Install the supply and return hoses to the vehicle and the retainers.
Connect the BPMV return hose quick connect (1).
Ensure the return hose quick connect is fully engaged by attempting to pull the return hose from the outlet fitting.

Fig 2: Identifying BPMV Supply Hose Quick Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Connect the BPMV supply hose quick connect (1).
Ensure the supply hose quick connect is fully engaged by attempting to pull the supply hose from the inlet fitting.

Fig 3: Identifying ABS Module Splash Shield

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield (1).

Fig 4: Identifying ABS Module Splash Shield Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the ABS module splash shield bolts (1) and tighten to 20 N.m (15 lb ft).

Fig 5: Identifying Antilock Brake System (ABS) Module Splash Shield Retainer

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield retainer (1).
Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
Lower the vehicle.

Fig 6: View Of Brake Master Cylinder Reservoir Return Hose Quick Connect & Supply Hose Quick Connect

Courtesy of GENERAL MOTORS CORP.

Connect the brake master cylinder reservoir return hose quick connect (1).
Connect the brake master cylinder reservoir supply hose quick connect (2).
Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling (Non-Hybrid) or Master Cylinder Reservoir Filling (Two-mode Hybrid) .