Torque Converter Housing with Fluid Pump Removal
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
CAUTION:
The valve body assembly must be removed prior to removing the torque converter (with fluid pump) housing assembly. Failure to ensure this will cause severe damage to both fluid pump seal assemblies. Also, the load of the valve body pushing on the seals, which in turn push on the pump, may prevent proper pump installation into the case. Refer to control valve body assembly removal.
|
|
| 1 | Turbine Shaft (O-ring) Seal |
| 2 | Bolt M10 x 50 (Qty: 9) |
| 3 | Torque Converter (With Fluid Pump) Housing Assembly |
| 4 | Fluid Pump Seal |