LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - Introduction (1 Of 2)) >> Repair Instructions >> Power Brake Booster Vacuum Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Lightly coat the brake booster vacuum sensor grommet with clean engine oil before installing the sensor.
    Fig 1: View Of Brake Booster & Vacuum Sensor
    GM1703767Courtesy of GENERAL MOTORS CORP.
  1. Install the brake booster vacuum sensor grommet to the brake booster.
  2. Install the brake booster vacuum sensor to the brake booster.
    3. Fig 2: View Of Wiring Harness Electrical Connector
    GM1703744Courtesy of GENERAL MOTORS CORP.
  3. Connect the chassis wiring harness electrical connector (1) to the brake booster vacuum sensor.
scientia non olet · About LEMON Manuals