LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - Introduction (1 Of 2)) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness Electrical Connector & Components
    GM1698087Courtesy of GENERAL MOTORS CORP.
  1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (2) from knock sensor.
    3. Fig 2: View Of Right Side Knock Sensor & Bolt
    GM1402140Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals