LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - Introduction (1 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (2500 Series - Cab/Chassis) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear HO2S, CPA Retainers & Electrical Connectors
    GM1856442Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Heated Oxygen and Oxygen Sensor Caution
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the connector position assurance (CPA) retainer (5).
  3. Disconnect the HO2S electrical connector (6) from the engine wiring harness electrical connector (7).
    4. Fig 2: View Of Catalytic Converter HO2S
    GM1856443Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Excessive Force and Oxygen Sensor Caution
  4. Remove the HO2S (3).
scientia non olet · About LEMON Manuals