Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Position the fuel level sensor over the slot in the reservoir and slide the sensor down into the slot.
- Ensure that the fuel level sensor retainers (1) engage the module reservoir.
- Install the fuel level sensor wiring pigtail under the module clip (2) behind the fuel pump wires.
- Connect the fuel level sensor wiring pigtail electrical connector (1) to the module cover.
- Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (25 Ext/Crew Cab w/26 Gal Tank) , Fuel Tank Fuel Pump Module Replacement (15/25 Reg/Ext/Crew Cab w/34 Gal Tank) , Fuel Tank Fuel Pump Module Replacement (15 Ext/Crew Cab w/26 Gal Tank) , Fuel Tank Fuel Pump Module Replacement (15 Reg Cab w/26 Gal Tank) or Fuel Tank Fuel Pump Module Replacement (35 Reg/Ext/Crew Cab w/34 Gal Tank) .