LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - Introduction (1 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (Rear of Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Vent Solenoid Hose, Filter, Connector & Strap
    GM2161155Courtesy of GENERAL MOTORS CORP.
  1. Use a hose clamp (1) at the end of the vent hose.
  2. Ensure the filter (3) points down.
  3. Secure the vent hose with a tie strap (2) to the vent hose tee connector (4).
  4. Secure the remaining portion of the vent hose along the frame with tie straps as needed.
    5. Fig 2: View Of Evaporative Canister Vent Solenoid
    GM2161179Courtesy of GENERAL MOTORS CORP.
  5. Position and install the evaporative canister vent solenoid (1) to the vehicle.
  6. Secure both ends with hose clamps (2).
scientia non olet · About LEMON Manuals