Windshield Wiper Arm Replacement (LD)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Open the hood in order to access and remove the wiper arm assembly. |
|
| 1 | Windshield Washer Arm Finish Cap Tip: Use a small flat-bladed tool to remove the finish cap. |
| 2 | Windshield Washer Arm Nut
CAUTION:
Refer to Fastener Caution
. Tip: Hold the wiper blade to the vertical black bar target mark located at the lower center portion of the windshield. Tighten: 30 N.m (22 lb ft) |
| 3 | Windshield Washer Arm Hose Tip: Rotate the hose clockwise around the end of the washer wiper arm upon installation. |
| 4 | Windshield Washer Arm Assembly Tip: Use the J 39637 . Special Tools: J 39637 Wiper Arm Puller |
| 5 | Windshield Washer Blade Assembly Tip: Pinch the 2 outer tabs on the arm, rotate the blade rearward and slide the blade forward to release the wiper blade from the wiper arm assembly. |