Windshield Washer Hose Replacement

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Windshield Washer Pump Hose Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Open the hood. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement . Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) . Place a clean suitable container under the vehicle prior to disconnecting the washer hose. Disconnect the washer hose from the washer pump spout.
1	Windshield Washer Hose Retainer Clip
2	Windshield Washer Nozzle Hose Tip: Disconnect the hose at the left rear fender flange.
3	Windshield Washer Pump Hose Assembly Tip: Route the new hose in the same location as the old hose was removed from.