LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to SIR Warning .
  1. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  2. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    3. Fig 1: Inserting J 42759 Into The Lock Cylinder Housing To Release The Tabs On The Ignition Switch
    GM1413831Courtesy of GENERAL MOTORS CORP.
  3. Insert release tool J-42759  into the ignition lock cylinder case to release the tabs on the ignition/start switch. See Special Tools .
  4. Pull the ignition and start switch out of the ignition lock cylinder case.
  5. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About LEMON Manuals