LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition lock cylinder case (1) to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the 3 ignition lock cylinder case screws (2).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  3. Install the park lock cable into the lock cylinder housing.
  4. Connect the passlock and key buzzer to the ignition lock cylinder case.
  5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement .
scientia non olet · About LEMON Manuals