LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> 175 Amp Mega Fuse Replacement (With Auxiliary Battery) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuse Cover & Connectors
    GM1857176Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  2. Remove the mega fuse cover.
    3. Fig 2: View Of Solenoid Cable Terminal & Nut
    GM1857420Courtesy of GENERAL MOTORS CORP.
  3. Remove the starter solenoid cable nut (1) from the fuse stud.
  4. Remove the starter solenoid cable terminal (2) from the fuse stud.
    5. Fig 3: View Of Positive Cable Nut, Jumper Cable Terminal & Fuse Nut
    GM1857184Courtesy of GENERAL MOTORS CORP.
  5. Remove the auxiliary battery positive cable nut (1) from the mega fuse holder.
  6. Remove the generator battery jumper cable to fuse nut (3).
  7. Remove the generator battery jumper cable terminal (2) from the fuse stud.
  8. Remove the auxiliary battery positive cable from the fuse studs.
    9. Fig 4: View Of Mega Fuse & Nut
    GM1857459Courtesy of GENERAL MOTORS CORP.
  9. Remove the upper mega fuse nut (1), if necessary.
  10. Remove the appropriate mega fuse (2).
scientia non olet · About LEMON Manuals