Connect Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Applying A Few Drops Of Clean Engine Oil To The Male Connection End

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Fuel Pipe Fitting Warning .

Apply a few drops of clean engine oil to the male connection end.

Fig 2: View Of Connecting Quick-Connect Fittings

Courtesy of GENERAL MOTORS CORP.

Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.

Fig 3: View Of Quick-Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Once installed, pull on both sides of the connection in order to make sure the connection is secure.
Install the fuel fill cap.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) or Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .