LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of IAT Sensor & Electrical Connector
    GM1602068Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the IAT sensor (2) to the center intake manifold.

    Tighten:  Tighten the sensor to 25 N.m (18 lb ft).

  2. Connect the engine wiring harness electrical connector (1) to the IAT sensor pigtail.
  3. Install the air intake pipe. Refer to Air Intake Pipe Replacement .
scientia non olet · About LEMON Manuals