LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Fuel Tank Filler Hose Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel and vent holes in the fuel tank.
  2. Install the fuel fill and vent hoses to the tank.
    CAUTION: Refer to Fastener Caution .
  3. Tighten the fuel fill and vent hose clamps (1, 2) at the tank.

    Tighten:  Tighten the clamp to 2.5 N.m (22 lb in).

    4. Fig 2: View Of Fuel Feed & Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel feed and pressure balance rear lines. Refer to Metal Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals