LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Fuel Pump Replacement (Aux Tank, Balance) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pump & Bracket
    GM19671Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel lines.
  2. Install the NEW fuel line O-rings.
  3. Position the new balance pump into the bracket.
    4. Fig 2: Identifying Fuel Pipes At Pump
    GM19670Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Connect the fuel lines to the balance pump. Use a backup wrench to prevent the pump from turning.

    Tighten:  Tighten the fittings to 30 N.m (22 lb ft).

  5. Lower the vehicle.
    6. Fig 3: View Of Sending Unit Electrical Connector (Cab/Chassis - Rear)
    GM1333147Courtesy of GENERAL MOTORS CORP.
  6. Connect the balance pump electrical connector.
  7. Tighten the fuel fill cap.
  8. Using a scan tool, command the fuel transfer pump on.
  9. Prime the fuel system. Refer to Fuel System Priming .
  10. Start the engine. If the engine stalls, repeat the above step.
  11. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals