LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use a NEW EGR valve gasket when installing the EGR valve.
    Fig 1: View Of EGR Valve, Bolts & Gaskets
    GM1873229Courtesy of GENERAL MOTORS CORP.
  1. Position a NEW EGR valve to valve cooler gasket to the valve cooler.
  2. Position the EGR valve (3) to the valve cooler.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the EGR valve bolts (2).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Install NEW EGR valve gaskets (1) onto the EGR valve, if required.
  5. Install the EGR valve cooler. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
scientia non olet · About LEMON Manuals