LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying ECM Retaining Tabs
    GM1603136Courtesy of GENERAL MOTORS CORP.
  1. Place the bottom edge of the ECM into the bracket lower retainers.
  2. Push the ECM towards the bracket until the upper edge of the ECM snaps into place.
    3. Fig 2: Identifying ECM Electrical Connectors
    GM1612203Courtesy of GENERAL MOTORS CORP.
  3. Connect the ECM electrical connectors (2).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) or Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  5. If a NEW ECM was installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals