Removal Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Relieve the fuel system pressure. Refer to the Fuel Pressure Relief (With CH-48027) or Fuel Pressure Relief (Without CH-48027) .
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Drain the fuel tank. Refer to Fuel Tank Draining .
- Remove the fuel tank shield bolts (1) and the fuel tank shield (2).
- Loosen the fuel fill (1) and vent pipe (2) hose clamps.
- Disconnect the hoses.
- With the aid of an assistant, support the fuel tank.
- Disconnect the evaporative emissions lines and the fuel lines. Refer to Metal Collar Quick Connect Fitting Service and Plastic Collar Quick Connect Fitting Service
- Disconnect the electrical connectors.
- Remove the fuel tank strap bolts (1) and the auxiliary fuel tank (2).
- Remove the fuel pump module from the fuel tank. Refer to Fuel Tank Fuel Pump Module Replacement (25 Ext/Crew Cab w/26 Gal Tank) or Fuel Tank Fuel Pump Module Replacement (15/25 Reg/Ext/Crew Cab w/34 Gal Tank) or Fuel Tank Fuel Pump Module Replacement (15 Ext/Crew Cab w/26 Gal Tank) or Fuel Tank Fuel Pump Module Replacement (15 Reg Cab w/26 Gal Tank) or Fuel Tank Fuel Pump Module Replacement (35 Reg/Ext/Crew Cab w/34 Gal Tank) .
- Cap the fuel and EVAP pipes in order to prevent possible fuel system contamination.