Rear Side Door Front Auxiliary Weatherstrip Replacement (Extended Cab)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Front Auxiliary Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement .
1	Rear Side Door Auxiliary Weatherstrip Procedure Lift up on the outside front upper corner of the outer sealing strip and pull away from the door. Remove the clips that retain the weatherstrip to the door. It may be necessary to drill new locating holes when installing the new weatherstrip. Press the weatherstrip firmly in place to ensure full adhesion is made to the door frame.

Callout

Component Name

Preliminary Procedure:
Remove the rear side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement .

Rear Side Door Auxiliary Weatherstrip

Procedure

Lift up on the outside front upper corner of the outer sealing strip and pull away from the door.
Remove the clips that retain the weatherstrip to the door.
It may be necessary to drill new locating holes when installing the new weatherstrip.
Press the weatherstrip firmly in place to ensure full adhesion is made to the door frame.