Hood Replacement

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hood & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure Disconnect the hood strut. Refer to Hood Strut Replacement . Remove the air inlet panel end panels. Refer to Air Inlet Grille Panel Replacement .
1	Hood Link Upper Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 25 N.m (18 lb ft) Tip: Disconnect any electrical connectors before removing.
2	Hood Hinge Pivot Bolt (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Hood Tip: Disconnect any electrical connectors before removing. Transfer any parts as needed.