LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1305 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Door Opening Weatherstrip Replacement (Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Weatherstrip & Pinch-Weld Flange
    GM1673255Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Install the weatherstrip (1) to the pinch-weld flange (2). Ensure that the weatherstrip is fully seated around the door opening.
  3. Install the windshield pillar molding. Refer to Windshield Pillar Garnish Molding Replacement .
  4. Install the body lock pillar trim. Refer to Body Lock Pillar Trim Replacement (Crew Cab) , Body Lock Pillar Trim Replacement (Extended Cab) or Body Lock Pillar Trim Replacement (Regular Cab)
  5. Install the hinge pillar trim. Refer to Body Hinge Pillar Trim Panel Replacement .
  6. Install the sill plate. Refer to Front Side Door Sill Trim Plate Replacement (Extended Cab) , Front Side Door Sill Trim Plate Replacement (Regular Cab/Crew Cab) , Rear Side Door Sill Trim Plate Replacement (Crew Cab) or Rear Side Door Sill Trim Plate Replacement (Extended Cab) .
  7. Inspect the door closing effort and seal to door fit.
scientia non olet · About LEMON Manuals