LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1304 (Fixed & MOVEABLE Window System) >> Diagnostic Information and Procedures >> Power Windows Malfunction (A31/AN3/DL3) >> Circuit/System Testing >> Rear Passenger Window Malfunction

Rear Passenger Window Malfunction

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.
  2. Test for less than 1 ohm between the ground circuit terminal F and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal G and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Enable the rear window switches by using the window lockout switch on the driver master control.
  5. Test for greater than 9 volts between the control circuit terminal D and ground.
    • If less than the specified range, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
  6. Test for greater than 9 volts between the signal circuit terminal C and ground while commanding the rear window DOWN with a scan tool.
    • If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
  7. Test for greater than 9 volts between the signal circuit terminal A and ground while commanding the rear window UP with a scan tool.
    • If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
  8. Ignition OFF, connect the harness connector at rear window switch and disconnect the harness connector at the rear window motor.
  9. Connect a test lamp between the control circuit terminal A and control circuit terminal B.
  10. Ignition ON, command the rear window UP and DOWN by using the rear window switch. The test lamp should illuminate when commanding the UP and DOWN states.
    • If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or open/high resistance. If the circuits test normal, replace the rear window switch.
    • If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the rear window switch.
  11. If all circuits test normal, test or replace the rear window motor.
scientia non olet · About LEMON Manuals