LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1304 (Fixed & MOVEABLE Window System) >> Diagnostic Information and Procedures >> Power Rear Sliding Window Malfunction >> Component Testing >> Sliding Rear Window Switch

Sliding Rear Window Switch

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the sliding rear window switch.
  2. Test for infinite resistance between the control terminals C and B and the voltage terminal A with the switch in the INACTIVE position.
    • If less than the specified value, replace the sliding rear window switch.
  3. Test for less than 2 ohms between the control terminal C and the voltage terminal A with the switch in the CLOSE position.
    • If greater than the specified range, replace the sliding rear window switch.
  4. Test for less than 2 ohms between the control terminal B and the voltage terminal A with the switch in the OPEN position.
    • If greater than the specified range, replace the sliding rear window switch.
scientia non olet · About LEMON Manuals