LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (With L9H and TP2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuse Cover & Connectors
    GM1857176Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover (3).
  4. Fig 2: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  5. Open the starter solenoid cable cover at the positive battery terminal.
  6. Loosen the starter solenoid cable nut (5).
  7. Remove the starter solenoid cable from the positive battery terminal.
  8. Remove the starter solenoid cable clip (4) from the air conditioning (A/C) evaporator tube.
  9. Fig 3: View Of Solenoid Cable Terminal & Nut
    GM1857420Courtesy of GENERAL MOTORS CORP.
  10. Remove the starter solenoid cable nut (1) from the mega fuse stud.
  11. Remove the starter solenoid cable terminal (2) from the mega fuse stud.
  12. Fig 4: View Of Oil Pan Skid Plate & Bolts
    GM1698083Courtesy of GENERAL MOTORS CORP.
  13. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  14. Remove the front 2 oil pan skid plate bolts, loosen the rear 2 bolts and remove the skid plate.
  15. Fig 5: View Of Starter Solenoid Cable Clip & Bolt
    GM1702990Courtesy of GENERAL MOTORS CORP.
  16. Remove the starter solenoid cable clip (1) from the wheelhouse panel.
  17. Remove the starter solenoid cable clip bolt (2) from the frame.
  18. Fig 6: View Of Starter Solenoid Cable & Nut
    GM1699544Courtesy of GENERAL MOTORS CORP.
  19. Remove the starter solenoid cable nut (1) from the starter.
  20. Remove the starter solenoid cable (2) from the starter.
  21. Lower the vehicle.
  22. Fig 7: View Of Starter Solenoid Cable
    GM1702991Courtesy of GENERAL MOTORS CORP.
  23. Remove the starter solenoid cable from the vehicle.