LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (6.6L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Indicator Tube Bracket & Bolts
    GM1873088Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  2. Remove the fan assembly. Refer to fan replacement Fan Replacement (Mechanical) or Fan Replacement (Diesel) .
  3. Remove the intake air heater. Refer to Intake Air Heater Replacement .
  4. Remove the generator. Refer to Generator Replacement (4.3L) , Generator Replacement (6.6L)  or Generator Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
  5. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  6. Remove the engine wiring harness clip from the oil level indicator tube bracket (2).
  7. Remove the oil level indicator tube bolt (3).
  8. Remove the oil level indicator tube bracket bolts (1).
  9. Remove the oil level indicator tube bracket (2).
    10. Fig 2: View Of Fuel Filter Adapter Stud, Generator Bracket Stud & Inlet Hose Bracket Nuts
    GM1871896Courtesy of GENERAL MOTORS CORP.
  10. Remove the heater inlet hose bracket nut (4) from the fuel filter adapter stud (1).
  11. Remove the heater inlet hose bracket nut (3) from the generator bracket stud (2).
  12. Reposition the heater inlet hose/pipe for clearance.
    13. Fig 3: View Of Fuel Feed Pipe Bracket Bolts
    GM1874235Courtesy of GENERAL MOTORS CORP.
  13. Remove the fuel feed pipe bracket bolts (1).
    14. Fig 4: View Of Engine Wiring Harness Clip Bolt
    GM1874236Courtesy of GENERAL MOTORS CORP.
  14. Remove the engine wiring harness clip bolt (1).
  15. Reposition the engine wiring harness out of the way.
    16. Fig 5: View Of Generator Bracket Bolts & Idler Pulley Bolts
    GM1874237Courtesy of GENERAL MOTORS CORP.
  16. Remove the generator bracket bolts (1) and nuts.
  17. Remove the generator bracket.
  18. If replacing the generator bracket, remove the idler pulley bolts (2) and remove the pulleys from the generator bracket.
scientia non olet · About LEMON Manuals